P1040 F grade little solvent impregnting palnt
1.Product introduction
  This product is diluted by little polar solvent ,such as modified epoxy ,tongma acid anhydride and auxiliary agent .it is featured with good dielectric property,heat-resistance ,three proof and good mechanical performandce with the best storage stability .With good immersion & baking manufacturability,higher solid content,low viscosity,low curing temperature ,short time ,strong adhesive force .The product can be used for insulation processing of F grade motor,electrical appliances ,also general purpose between B & F grade.
2.Technological requirements:
No.
 Index name
Unit
 Index value
1
appearance
Transparent liquid ,no mechanical impurity
2
 Viscosity,#4 viscosimeter23±1
S
20-50
3
 Solid content,120℃ 1h, 150℃ 2h 10g
%
 70±4
4
 gelling time 140±2℃
h
 ≤4
5
 Cure capability for the thick layer ,45×45×25mm Aluminium box 10g 120℃ 1h 150℃ 2h
Equal to S1 U1 I4.2
6
 Thermoelasticity,180±2℃
h
 ≥48
7
 Dielectric strength,ordinary state after soaking 24h under 23±2℃
MV/m
 ≥60
≥40
8
 Volume resisitivity
Ordinary state
24h under 23±2℃ water 155±2℃
MΩ.m
 ≥1×1012
≥1×1011
≥1×108
3.application instruction
  Every kindof motor &electrical appliance should be immersed in varnish for 20-30 min under 50℃,drained 30 min,baked 7-10 hours under 140±5℃.Using xylene solvent to regulate the viscosity. This varnish should be sealed in cool & dry room temperature ,storage duration is 3 months.This product exceeding storage durage also can be used through qualified test.
中国国情网.蓬莱之窗策划制作